6 days ago · 83 Caballero Has anyone replaced the temperature door pivot. Can it be done on the outside or do I need to pull the case.

Nov 10, 2011 · Beepster, you will need to remove the heater controls from the dash- just unscrew and push back inside the dash. To get the speedo cable to release, you need to pull forward on the small …

Aug 2, 2014 · Charcoal canister I'm a little hesitant to pay $67 for a new canister...When you guys say just pull off the hose,I'm thinking you're talking about the hose from the TANK..Correct???

Mar 27, 2004 · I'm removing the door panels from my 84 elky so I can replace the window felts, but I'm running into problems. Can anyone please tell a newbie how to remove the covers over the ends of …

Apr 20, 2018 · I have a 1985 el camino. The 9 port vacuum switch for the heater control broke. Eklers can no longer get this part. Am I up a creek? Do I have to check junk yards for this part? Is there a …

Nov 9, 2013 · Troubleshooting 5th Gen AC/Heat Vent Door Part 2 The lower heat door is harder to get to. Some say to remove the radio first, I was able to get to it by crawling under and removing a screw …

Feb 20, 2004 · Immediately upon starting, a vacuum operated "choke pull off" diaphragm will pull (just barely crack open) the choke plate allowing a small amount of air to pass into the carburetor. As the …

Mar 29, 2005 · I will also pull the heads and have a shop perform a basic valve job and replace any worn parts at that time. I will keep the stock distributor and freshen it up with new cap, rotor, and plug …

Apr 22, 2012 · Looking at the front of the carb you will see a port just to the right of the fuel inlet and above the right side idle mixture screw. This is where the factory connected on most for advance. If …

May 5, 2012 · Hello all, I'm currently in the middle of a full-on HEI rebuild with the goal in mind to maximize timing performance to achieve the best possible fuel economy. We're not talking your basic …